Join 2 lengths of Dyneema... Join 2 lengths of Dyneema...
| 1. | Trim the end of each length of line to be joined and heat seal to prevent fraying |
| 2. | Thread
the sleeving needle through the hollow centre of the cut
sleeving length |
| 3. | Thread
one end of your line through the loop at the end of the
sleeving needle |
| 4. | Pull the needle back through the sleeving pulling the end of the line with it until 1cm of line shows |
| 5. | Repeat for the other length of line |
| 6. | Tie
a simple overhand knot in the sleeving and line for each
length  |
| 7. | Thread
the sleeving needle through one length of sleeved line as
shown below |
| 8. | Using
the needle thread one sleeved line through the second as
below |
| 9. | Thread
the second sleeved line through the first as below... |
| 10. | Pull
the two lengths tight as shown below and knot each end |